PIAA 530 Series L.E.D. - Manual (Page 4)

-4-
PKI-0007-3
● When using a bracket available on the market, make sure the bolts you remove from the vehicle does
not hinder its performance.
● Do not install on an unstable location, it may come lose while
driving. This may affect the overall life of the bulb. In addition
it may damage the vehicle or the main body of the lamp.
Make sure you install the lamp on a stable and secure location.
● Do not install on a vertically-surface (refer the image
on right hand).
◆ When you have decided the installation method……
(1) Rearrange the bracket according to your needs,
and apply double-side tape (Item 3) and one-side
tape as shown in the diagram below.
(2) Hold the lamp up to where it will be installed on the
vehicle. Verify the gap between the lamp and
surrounding obstacles.
Check !
Make sure the installation
position is correct and the
logo will not be upside down.
Bracket
Lamp body
Phillips head driver
Double-stick tape
(Item 3)
●ランプを市販のテープや両面テープ等で仮止めしてください。
tape
● Temporarily set the bracket with tape.
● Make sure to set position properly before permanently
setting the lamp. Also, thoroughly clean the surface of
the installation position beforehand.
● Make sure to remove the tape glue on the vehicle body
after installation.
● Make sure the lamp can be adjusted up and down
(beam must be adjusted so that it shines at least
40m ahead of the vehicle.) If it cannot be adjusted,
it must be re-installed.
● There must be between 30mm to 35mm on either
side of the lamp to allow for proper adjustment.
● If using a screw, make sure there is adequate space
between the bracket and the lamp(where screw
will be inserted).