PIAA 530 Series L.E.D. - Manual (Page 3)

-3-
PKI-0007-3
※ Please use the tools indicated below.
● Phillips head driver
※ Verify all the parts are included. If a part is missing, please contact your local distributor.
Product Details
switch
● Tape ● Pliers
Tools Required
① Lamp main unit (2 units) ② Switch harness set
[1 set]
④ One-touch connector (1pc) ⑤ Wire tie (5 pcs) ③ Double-stick tape (2 pcs)
● Electric drill ● File ● Holesaw( φ 20mm )
● Using the holes in the lamp bracket, the height from the lamp body to the installation surface can be
adjusted. Depending on the top and bottom measurements as well as shape.
● In case the mounting surface is not flat position or is not enough space of it s surface, please make
sure to fix the lamp stably by using double-stick tape and screws(sell separately).
【1】Lamp installation preparations and temporary setup
Type Ａ
91mm
74mm
100mm
74mm
Mounting that combines bracket and lamp
Type B