Initialising a new system – Paxton Vandal resistant compact metal keypad User Manual
Page 3

This box can be used to write down the Programming Code for future reference.
Ensure that this information is stored in a secure place.
X
Single or multiple
codes
Silent operation
20 wrong keystrokes
= 60 second lockout
Door open time
(seconds)
Change
Programming Code
Exit button
Set a
user code
Data Reset (except
Programming code)
OR
One code only
Multiple codes allowed
Silent
Beep on
OFF
ON
Enter time in seconds
(default = 07, max = 60)
Open door for
time in option 5
Toggle door open
until pressed again or
toggle code entered
Enter user code
4-8 digits
Re-enter
user code
Enter 6 digit
Programming
Code
= Delete
= Normal
= Toggle
= Duress
Enter 6 digit
Programming
Code
Re-enter 6 digit
Programming
Code
6
OR
OR
X
OR
2
4
6
8
OR
OR
OR
Lock wire setting
Fail locked
Fail open
OR
2
2
2
2
2
2
1
3
4
7
5
6
9
8
6
6
6
6
9
START - Enter the 6 digit Programming Code and hold down a function key
for
3 seconds. - The unit beeps and the LED flashes faster.
Continue the key sequence to set the option - The keypad returns to operating mode.
= default setting
= Hold down for 3 secs
Choose a 6 digit Programming Code and load this into the unit as follows:
IMPORTANT: Do not set the Programming Code to 123456.
The default user code is 1234 - the programming code must not include 1234 in the same order.
The door lock will release after 1234 and ignore any remaining numbers.
The default user code is now set to 1234
Initialising a new system
You can now set up the user codes and features using the programming chart.
Example: - Setting a user code to unlock the door under Normal conditions.
Enter user code
4-8 digits
Re-enter
user code
4
8
Enter 6 digit
Programming
Code
Hold for 3 secs
The unit will beep and the LED flashes faster
Enter 6 digit
Programming
Code
Re-enter 6 digit
Programming
Code
Normal