D-sub inducom, Mvb backbone interface set, Wtb backbone interface set – Northern Connectors Harting D-sub Connectors, Housings & Accessories User Manual

Page 167: Inducom 9 – industrial bus interface system

166

D-Sub

66 63 009 5013

66 63 009 5014

D-Sub InduCom

Further bus PCBs on request

* To check compatibility with cable types and manufacturers, please contact your local HARTING representative.

InduCom 9 – Industrial bus interface system

MVB Interface

WTB Interface

Identification

Part No.

General information

MVB backbone interface set

The Multifunctional Vehicle Bus (MVB) backbone

interface is specially designed for communication

cables in Train Control Networks (TCN). With this

interface it is possible to realise a T-bus structure with

MVB-cable with which you can disconnect the bus

interface from the control unit without any interruption

of the complete bus communication. On the PCB you

will have load resistors and test capacitors which

can be activated with solder bridges. The wires are

terminated with the proven vibration resistant cage

clamp technology.*

Components of the MVB interface set:

●

1 metal housing with 2 cable entries

●

2 hexagonal screws with UNC 4-40 threads

●

1 PCB with 9 way D-Sub male connector and cage

clamps

●

2 crimp flanges for the MVB cable

●

2 crimp ferrules for the MVB cable

●

1 blanking piece

WTB backbone interface set

The Wired Train Bus (WTB) backbone

interface

is specially designed for backbone cables in Train

Control

Networks (TCN). With this

interface it is

possible to realise a T-bus structure with WTB-cable

with which you can disconnect the bus interface from

the control unit without any interruption of the complete

bus communication. On the PCB you will have load

resistors and test capacitors which can be activated

with solder bridges. The wires are terminated with the

proven vibration resistant cage clamp technology.*