Rs-232 pump network connector wiring, Accessories – New Era NE-4000 Multi-Phaser Programmable Double Syringe User Manual
Page 50

New Era Pump Systems Inc.
www.SyringePump.com
Model NE-4000 Multi-Phaser™
Publication #1200-01
45
09/05/14
11.2
RS-232 Pump Network Connector Wiring
RS-232
To Network To Computer
PC Com Port Connectors
25 Pin
9 Pin
3 - Receive
2 - Receive
Connect to pump TXD
2 - Transmit
3 - Transmit
Connect to pump RCV
9 - Ground
5 - Ground
Connect to pump GND
11.3
Accessories
11.3.1
ANA-BOX™
Part #: ADPT-ANABOX, Analog voltage control interface.
Allows the pump to be controlled by a variable voltage source. Allows the Creation of a closed loop system
allowing the NE-4000 to be controlled by an external sensor, such as a pressure sensor, or other variable voltage
source. Start or stop the pump at a specific voltage level. Set the pumping rate to be proportional to the voltage
input.
11.3.2
Syringe Heater
Part#: SYRINGE-HEATER, Visit
www.SyringeHeater.com
for details.
Flexible heating pad that wraps around the syringe. Thermo-Kinetic Heat Clamping digital controller will heat a
syringe to a set temperature up to 100 C.
11.3.3
RS-232 Network Cables
RS-232 Network Primary Cable
7 foot cable, part #:
CBL-PC-PUMP-7
25 foot cable, part #:
CBL-PC-PUMP-25
Cable to connect a pump, or the first pump in a pump network, to a standard personal computer’s serial port with a
DB-9 or DB-25 connector. Included with this cable is a 9 pin to 25 pin converter.
RS-232 Network Secondary Cable
7 foot cable, part #:
CBL-NET-7
25 foot cable, part #:
CBL-NET-25
Cable to connect additional pumps, after the first pump, to the pump network.
USB to RS-232 Converter Cable
USB to RS-232 cable, software drivers on CD, part#: CBL-USB232
Attached to the RS-232 Network Primary Cable, allows communication through a PC’s USB port.
11.3.4
Automation Cable: Special Communications Modes Control Cable
Part #: CBL-DUAL-3
Using two NE-4000 syringe pumps, this cable either creates an automated, continuous operation pumping system,
whereby one pump is refilling while the other is dispensing, or creates a dual pumping system, with both pumps
operating in the same direction. Plus other special communications modes.
RCV from network
TXD to network
TXD to computer
RCV from computer