Multiquip PS706036 - Manual (Page 43)

PS7060 MULTIQUIP SAW • OPERATION MANUAL — REV. #2 (06/02/08) — PAGE 43
PS7060 MULTIQUIP SAW — MAINTENANCE
Cooling System
Refer to your engine manual for additional information.
Figure 45. Air Cleaner Removal
The Deutz 2011 Series Engine uses a robust, heavy duty oil
cooler system to cool the engine. The cooling system will benefit
from periodic inspection and cleaning.
1. Disconnect the Air Intake Hose at the Lifting Bale, (item A,
Figure 45).
2. Remove 3 bolts that mount the air filter bracket to the engine,
(item B) and cover the oil cooler, (C).
3. Remove the Air Box Cover, (Item D).
4. Use a nylon bristle brush to gently brush the underside of
the oil cover to break loose any accumulated dirt and debris.
5. Using compressed air, carefully blow from the top of the oil
cooler to remove lodged dirt and debris. Blow out any dirt
out of the Air Box.
6. Use compressed air to next blow accumulated dirt and
debris from the Fan Air Intake, Fan, and Fan Tunnel.
7. Using a non-caustic degreasing agent, soak entire oil cooler
and let sit for several minutes. With low pressure water,
such as a garden hose with a spray nozzle, thoroughly
rinse Oil Cooler and Air Box out.
8. Re-install Air Box Cover, Air Filter Assembly and mount,
and tighten Air Intake Hose connector.
B
B
D
C
A
Battery/Charging System
Battery electrolyte contains corrosive,
toxic chemical. (dilute sulfuric acid).
Avoid contact with eyes and skin.
WARNING WARNING WARNING WARNING WARNING
Flammable, explosive gas. (produces
hydrogen gas while charging or during
operation). Keep area around battery
well ventilated and keep from any fire
source.
Shock or Fire due to electric short-
circuit. Disconnect battery cables
before inspecting electrical system
and never "spark" battery terminals
to test for charge.
2. Never attempt to charge a battery that is frozen. The battery
can explode unless first allowed to thaw.
3. Disconnect the negative terminal ( - ) of the battery during
storage. If unit will be stored where ambient temperature
will drop to -15
o C or less, remove and store battery in a
warm, dry place.
1. Check and clean battery terminals for corrosion.
This saw uses a Group 75, 12 Volt, 850 CCA (cold cranking
amp) AGM Technology battery.