Multiquip PS706036 - Manual (Page 30)

PAGE 30 — PS7060 MULTIQUIP SAW • OPERATION MANUAL — REV. #2 (06/02/08)
PS7060 MULTIQUIP SAW — WATER DELIVERY SYSTEMS
Water Delivery System
When storing the saw where temperatures may drop
below freezing, blow out the water lines to prevent damage
to the water delivery system.
CAUTION CAUTION CAUTION CAUTION CAUTION
1. Connect the water supply hose to the water inlet (garden
hose) fitting on the left side of the saw, (Item 21, Figure 6).
2. Verify that the water hose on the saw is connected to the
Blade Guard, (Figure 15), and that the water hoses or tubes
are pointed into both Blade Flanges.
Ensure that the hose ends maintain a 45 o angle and maintain a
light contact with the surface of the blade.
Installing the Flange Guard
The Flange Guard protects the Blade Flange not in use.
1. Slide the Flange Guard onto the Guard Mounting Tab on
the frame. (See Figure 20.)
2. Verify that the Blade Flange not in use is secured to the
Blade Shaft, by tightening the mounting bolt.
Figure 20. The Flange Guard Installed
1
2
3
5. The lever on the left side of the control panel regulates
water flow volume. The lever on the right side of the control
panel turns the water ON and OFF.
6. If the saw is equipped with an optional water pump, the
ON/OFF switch is located on the control panel next to the
water ON/OFF control valve.
3. Standard Water Delivery System : Ensure that the hose
ends maintain a 45 o angle and maintain a light contact with
the surface of the blade. (Figure 18.)
4. Water Jet Delivery System : Ensure that outlets of the water
tubes point toward the lower portion of the blade flanges,
aimed at the delivery ports, for proper water delivery to the
blade. (Figure 21.)
Figure 21. Large Bladeguard Water Tube