Multiquip PS706036 - Manual (Page 13)

PS7060 MULTIQUIP SAW • OPERATION MANUAL — REV. #2 (06/02/08) — PAGE 13
■ Verify the engine start switch is set to the OFF position before
installing a blade.
■ Use proper blades and follow the blade manufacturer's
recommendations. Match the blade RPM (Blade Shaft RPM)
to the recommended blade surface feet per minute. (SFPM).
■ Ensure the 5/8" blade-mounting bolt is tightened to 125-175
foot lbs. of torque.
■ Start engine with the Control Handle in the NEUTRAL
position to prevent unexpected saw movement.
■ Do not start engine on a sloping surface to prevent
unexpected loss of control.
■ If the saw must be parked on a slope and engine turned off,
ensure the parking brake is engaged and holds the saw
safely in place. Turning the saw across the angle of the slope
will help prevent accidental downhill movement. Block the
saw as well when leaving.
■ NEVER touch the hot exhaust manifold, muffler
or cylinder. Allow these parts to cool before
servicing the saw. Contact with
hot!
components can cause serious burns.
■ ALWAYS check the saw for loosened hardware such as nuts
and bolts before starting.
PS7060 MULTIQUIP SAW — RULES FOR SAFE OPERATION
■ DO NOT go near rotating parts, (blades,
belts, pulleys or wheels), while engine is
running.
■ NEVER place your
feet or hands inside the guards while
starting or operating this equipment.
■ No one other than the operator is to be in the working area
when the saw is in operation.
■ NEVER allow passengers or riders on the saw during
operation or transportation.
Pay close attention to ventilation when
operating the saw in confined spaces such
as tunnels, buildings or similar areas. The
engine exhaust contains harmful elements.
Ensure proper air flow to move engine
exhaust away from the operator.
DANGER DANGER DANGER DANGER DANGER
■ DO NOT use on excessive slopes or on extremely uneven
surfaces.
■ ALWAYS keep the work area well organized.
■ ALWAYS Clear the cutting area of any debris, tools, etc. that
would constitute a hazard while the saw is in operation.
ALWAYS check to make sure that the
cutting area is clear before starting the
engine.
WARNING WARNING WARNING WARNING WARNING
■ Keep all inexperienced and unauthorized people clear of
the cutting area when operating the saw.
■ Make certain all protective guards are securely in place
BEFORE operating the saw. This saw is supplied with a blade
guard, blade flange guard, and a belt guard.
■ Moving Parts – Shut down the engine before performing
service or maintenance functions. Contact with moving parts
can cause serious injury.
■ Keep the saw clean. It will perform better and last longer.
■ NEVER leave the machine
unattended while running.
■ Ensure brakes are applied when leaving or when using on a
slope. This saw utilizes a brake system where the brakes are
automatically applied when the engine is stopped.
■ NEVER run the engine without the air filter. Severe engine
damage could occur. Service air cleaner at recommended
service intervals to prevent engine damage.