Multiquip PS706036 - Manual (Page 35)

PS7060 MULTIQUIP SAW • OPERATION MANUAL — REV. #2 (06/02/08) — PAGE 35
3
5
1
4
6
PS7060 MULTIQUIP SAW — BLADESHAFT ENGAGE SYSTEM
Depth Control System
The PS7060 saw uses an electronically controlled Depth Stop
to position and lock the blade at the desired cut depth.
To Control the Depth of Cut with saw running and Blade Mounted:
1. Raise the saw above the desired cutting depth.
2. Turn the Depth Control Knob counterclockwis e until the
saw cannot be lowered by pushing the Raise/Lower Switch
forward. (Figure 31.)
Figure 31. Setting Depth Gauge and Depth
Stop
To disable the Depth Stop when it is not needed:
1. While holding the Raise-Lower toggle switch FORWARD,
rotate Depth Control Knob CLOCKWISE until saw is at full
depth position.
2. Rotate Depth Control Knob an additional 1-2 turns.
3. Hold the Raise/Lower Switch in the Lowering position and
rotate the Depth Control Knob
clockwise until desired
cutting depth is achieved. The saw will repeat to the same
depth until readjusted.
2. Turn the depth control knob counterclockwise until the saw
cannot be lowered by pushing the raise/lower switch
forward.
To Re-adjust for Full Cutting Depth:
1. Hold the Raise/Lower Switch in the Lowering position and
rotate the Depth Control Knob
clockwise until the saw is
fully lowered.
2. Rotate Depth Control Knob clockwise an additional 1 turn.
Bladeshaft Rotation Dis-engagement System
The engine MUST be at IDLE when engaging or dis-engaging
Bladeshaft Drive. (Item 1, Figure 32.)
To STOP Bladeshaft Rotation:
Push rocker switch labeled BLADESHAFT forward, (Item 2,
Figure 32). Engine will tilt forward, disengaging the belt drive.
To START Bladeshaft Rotation:
Push rocker switch labeled BLADESHAFT backward, (Item 2,
Figure 32). Engine will tilt back, engaging belt drive.
Raises
Lowers
2
1
1. Depth Control Knob
2. Raise/Lower Toggle Switch
3. Adjuster Bracket
4. Adjuster Cable/Spring assy.
5. Adjuster Nut
6. Depth Control Housing
2
1
Figure 32. Bladeshaft Engage/Dis-engage