Multiquip PS706036 - Manual (Page 39)

PS7060 MULTIQUIP SAW • OPERATION MANUAL — REV. #2 (06/02/08) — PAGE 39
B
A
Certain maintenance operations or machine adjustments
require specialized knowledge and skill. Attempting to
perform maintenance operations or adjustments without
the proper knowledge, skills or training could result in
equipment damage or injury to personnel. If in doubt,
consult your dealer.
WARNING WARNING WARNING WARNING WARNING
PS7060 MULTIQUIP SAW — MAINTENANCE
MAINTENANCE
When performing maintenance operations on
the saw or engine, follow all safety messages
and rules for safe operation stated here and
at the beginning of this manual.
See the engine manufacturer's manual
supplied with your machine for appropriate
maintenance schedule and troubleshooting guide for problems.
Accidental starts can cause severe injury or death!
WARNING WARNING WARNING WARNING WARNING
ALWAYS place the ON/OFF switch in
the OFF position.
Disconnect negative battery cable
from battery before servicing.
Engine and muffler surfaces can get
HOT! Allow to cool before servicing.
Daily (8-10 Hours)
1. Check fluid levels in engine and reservoir; fill as necessary.
2. Visually inspect for wear and damage.
3. Visually inspect for engine leaks.
4. Check or replace the engine air filters as necessary.
5. Check operation of Emergency Stop Button.
Monthly (125-150 Hours)
1. Change Hydraulic oil and filter. (First 125 hours, then every
250 hours.)
2. Change Engine oil and filter.
Yearly (500-600 Hours)
1. Replace fuel filter cartridge and v-belt.
2. Check fuel lines for leakage.
3. Check battery cables and connectors.
4. Check engine monitoring and warning system.
Air Cleaners (Daily)
While the air filters should be checked daily and replaced when
necessary, there is no need to "over-service" the air filters. That
is, they require no cleaning and do not require the use of oil. If
the primary filter becomes clogged, simply replace it.
The saw utilizes both a primary air filter and a safety air filter,
(Figure 40). The air filter restriction light, (Item A, Figure 39) on
the engine status indicator (Item B, Figure 39), will illuminate
when the filter is plugged.
Avoid slips and falls!
Clean up all engine oil, hydraulic
oil, and diesel fuel spills
immediately.
CAUTION CAUTION CAUTION CAUTION CAUTION
ALWAYS ensure saw is
SECURELY placed on appropriate
blocks or jackstands when
performing maintenance requiring
the saw to be elevated.
Figure 39. Air Filter Restriction Light
Empty the dust discharge valve daily and clean the discharge
slot from time to time. (Figure 40)
Maintenance Schedule