beautypg.com

Maintenance – Multiquip WTE5C Operation Manual User Manual

Page 27

background image

WT5C/WTe5C WaTer Trailer • operaTion manual — rev. #1 (06/05/13) — page 27

maintenanCe

Perform the scheduled maintenance procedures as defined

by Table 6 and below:

DAILY

„

Thoroughly remove dirt and oil from the engine and

control area. Clean or replace the air cleaner elements

as necessary. Check and retighten all fasteners as

necessary. Check the gearbox for oil leaks. Repair or

replace as needed.

Weekly

„

Remove the fuel filter cap and clean the inside of the

fuel tank.

„

Remove or clean the filter at the bottom of the tank.

„

Remove and clean the spark plug (Figure 22), then adjust

the spark gap to 0.024 ~0.028 inch (0.6~0.7 mm). This

unit has electronic ignition, which requires no adjustments.

Figure 22. Spark Plug Gap

engine oil

1. Drain the engine oil when the oil is warm as shown in

Figure 23.

2. Remove the oil drain bolt and sealing washer and allow

the oil to drain into a suitable container.

3. Replace engine oil with recommended type oil as

listed in Table 4. For engine oil capacity, see Table 1

(Specifications).

Do noT overfill.

4. Install drain bolt with sealing washer and tighten

securely.

0.024-0.028 IN.

(0.6-0.7 MM.)

GAP

Figure 23. Engine Oil (Draining)

engine air Cleaner

1. Remove the air cleaner cover and foam filter element

as shown in Figure 24.

2. Tap the paper filter element (Figure 24) several times

on a hard surface to remove dirt, or blow compressed

air [not exceeding 30 psi (207 kPa, 2.1 kgf/cm2)]

through the filter element from the air cleaner case

side.

never brush off dirt. Brushing will force dirt

into the fibers. Replace the paper filter element if it is

excessively dirty.

3. Clean foam element in warm, soapy water or

nonflammable solvent. Rinse and dry thoroughly. Dip

the element in clean engine oil and completely squeeze

out the excess oil from the element before installing.

Figure 24. Engine Air Cleaner

OIL FILLER CAP

DIPSTICK

DRAIN

BOLT

SEALING
WASHER

Danger

Do noT use gasoline as a cleaning solvent to avoid

creating the risk of fire or an explosion.

This manual is related to the following products: