Multiquip WTE5C Operation Manual - Manual (Page 17)

WT5C/WTe5C WaTer Trailer • operaTion manual — rev. #1 (06/05/13) — page 17
inspeCtion
engine oil CHeCk
1. To check the engine oil level, place the unit on secure
level ground with the engine stopped.
2. Remove the filler dipstick from the engine oil filler hole
(Figure 4) and wipe it clean.
Figure 4. Engine Oil Dipstick (Removal)
3. Insert and remove the dipstick without screwing it into
the filler neck. Check the oil level shown on the dipstick.
4. If the oil level is low (Figure 5), fill to the edge of the
oil filler hole with the recommended oil type (Table 4).
Maximum oil capacity is 0.63 quarts (0.6 liters).
Figure 5. Engine Oil Dipstick (Oil Level)
NOTICE
Refer to engine manufacturer’s manual for specific
servicing instructions.
UPPER LIMIT
LOWER LIMIT
Table 4. oil Type
Season Temperature oil Type
Summer 25°C or Higher SAE 10W-30
Spring/Fall 25°C ~ 10°C SAE 10W-30/20
Winter 0°C or Lower SAE 10W-10
Fuel CHeCk
1. Remove the gasoline cap located on top of fuel tank.
2. Visually inspect to see if fuel level is low. If fuel is low,
replenish with unleaded fuel.
3. When refueling, be sure to use a strainer for filtration.
Do noT top-off fuel. Wipe up any spilled fuel.
Danger
Motor fuels are highly flammable and can be
dangerous if mishandled. Do noT smoke
while refueling. Do noT attempt to refuel if
the engine is hot or running.