Multiquip VR36HA - Manual (Page 9)

VR-36HA • VIBRATORY ROLLER — PARTS & OPERATION MANUAL — REV. 6 (06/13/06) — PAGE 9
■ Remove mud, oil, ice, snow or any other slippery materials
from the ramps and bed of the vehicle to avoid accidents.
■ After loading, apply the parking brake, lock the frame with
the locking bar that is provided.
■ Use chain and binders or other suitable means to firmly
secure the load before attempting to move the vehicle.
BATTERY INFORMATION
DANGER! Lead acid batteries contain sulfuric acid which will
damage eyes, skin and clothing upon contact. Always wear proper
safety eye protection, rubber gloves and other safety clothing.
Should acid contact the eyes, flush immediately with clean water
and get prompt medical attention. If acid comes in contact with
skin, wash immediately with clean water and get prompt medical
attention.
DANGER! Avoid fire and open flame near batteries. Battery acids
are extremely flammable and explosion can result.
■ Clean and inspect battery terminals regularly.
■ Non-use of machine will result in reduced battery charge
level and will damage the plates which reduces the battery
life.
■ Keep battery caps tightly fastened at all times.
■ Add distilled water as needed
■ Proper sequence must be observed during installation and
removal of batteries:
■ Removal - Disconnect the negative (ground) terminal first,
then the positive terminal.
■ Installation - Install the Positive terminal first, then the
negative (ground) terminal.
DANGER! Never allow the negative and positive cables to come
in contact with each other. Serious injury could result.
VR-36HA — OPERATIONS
SERVICE AND INSPECTION
Performing all periodic inspections and service work on a timely
basis will result in increased performance, productivity and
reduced maintenance costs.
When the roller is used in severe, unusually dusty or dirty, or
extremely humid or hot environments, it will be necessary to
perform routine service and inspections more frequently.
DANGER! Always operate the machine in a well ventilated area.
Exhaust gasses are dangerous and cause injury or death. Never
operate this or any other machine within an enclosed space.
SERVICE INSTRUCTIONS CHART
Engine Speed 3500 RPM
Exciter Speed 3900 VPM
Exciter Lubrication Type SAE 30
16 oz. (475 ml)
Every 1100 hours
Grease Type Alvania #2 or equiv.
Articulated joint (4 fittings)
Static drum bearing (1 fitting)
Every 75 hours
Hydraulic Oil Type ISO46 (Anti-Wear)
5.7 gallons (21.6 liters)
Every 1100 hours
Hydraulic Filter Change every 500 hours
Engine Lubrication/ Refer to Engine Owners Manual
Service
CAUTION! Running the machine without sufficient hydraulic oil
will result in extreme damage to the unit’s hydraulic system.