Multiquip VR36HA - Manual (Page 58)

PAGE 58 — VR-36HA • VIBRATORY ROLLER — PARTS & OPERATION MANUAL — REV. 6 (06/13/06)
VR-36HA — SERVICE INFORMATION
4. Mark and disconnect all hoses and lines from the pump.
5. Disconnect the forward / reverse control cable.
6. Disconnect the pump support bracket.
7. Remove the engine mounting bolts.
8. Elevate the pump and engine assembly using a proper
lifting device.
9. Disconnect and remove the hydrostatic pump assembly.
10. Repair or replace the hydrostatic pump as required.
11. nstall the hydrostatic pump in the reverse order of removal,
using Locktite 271 on all mounting bolts and nuts.
12. Test operate. Test and adjust the forward and reverse relief
pressures as required. Adjust the forward / reverse control
cable.
2.8 Removing and Replacing Vibration / Steering Pump
1. Remove the hydrostatic pump as per preceding instructions.
2. Remove all hoses and lines.
3. Disconnect the vibration / steering pump and remove.
4. Repair or replace pump as required.
5. Install the pump in the reverse order of removal, using
Locktite 271 on all mounting bolts and nuts.
6. Test operate. Test and adjust the forward and reverse
pressure relief valves as required. Adjust the forward /
reverse control cable. Test and adjust the vibration and
steering pressure relief valves as required.