Purenex Multipure Aquaperform - Manual (Page 18)

1. using a paper towel or cloth, dry off all connections and the Dws housing.
2. Make sure that all connections are tightly secured.
3. Turn the water supply back on; rotate both the Adapta Valve shutoff valve and either the
water supply Angle stop Valve or water shutoff valve counter-clockwise to engage the
flow of water through the pipes.
4. Turn the handle on the Dws faucet to start the flow of filtered water.
5. Allow water to flow through the Dws and the faucet for five minutes. This purges any air
and loose carbon from the system.
6. Adjust the Angle stop Valve or water shutoff valve so that the water flow to the drinking
water faucet does not exceed the flow rate. nOTe: It takes approximately 20 seconds to
fill a quart at 1.0 gallons per minute flow rate.
7. Turn off the Dws faucet and check for leaks.
a.Check the V-Band to confirm that it is secured evenly around the top and bottom
housing halves.
b.Hand-tighten the black knob on the V-Band until it is as tight as possible.
8. Turn on the Dws faucet and allow water to flow for approximately 30 minutes. This will flush the filter and charge the
carbon.
9. Turn off the Dws faucet.
10. Check all connections to make sure that there are no leaks.
11. Congratulations! Your Dws is now ready for use.
If you have any questions regarding the installation of your
Multipure Drinking Water System, call:
Multipure International
Customer Service Department
7251 Cathedral Rock Drive
Las Vegas, NV 89128
702.360.8880 phone
800.622.9206 toll-free
702.360.8575 fax
email: [email protected]
www.multipure.com
18
3.7: Preparing and Operating Your Drinking Water System
Multipure Inline models are ideal for refrigerators, water coolers, or restaurants where all water to a
cold water outlet or faucet is filtered. Model MP880sI includes the housing, filter, bracket, and
screws. The inline models are appropriate for an inline installation and can be used with your existing
faucet. It is recommended that the inline models be installed by a professional plumber in accordance
with established plumbing procedures.
3.6: Installing the System for Inline Use