MotorGuide Pinpoint GPS - Manual (Page 22)

PRODUCT INSTALLATION AND OPERATION
16
eng
Storing or Overwriting an Anchor Position
a - Memory buttons (1–8)
NOTE: An anchor position can be stored or overwritten from any operating mode
except route record mode.
To store an anchor location, press and hold any of the numbered memory buttons
for two seconds. The unit will emit a tune to indicate that the anchor position has
been stored successfully.
A stored anchor position can be overwritten by simply storing a new anchor position
to the desired memory button.
Recalling a Stored Anchor Position
NOTE: A stored anchor position can be recalled from any operating mode.
To recall a stored anchor position, press and release the desired memory button.
The trolling motor will emit an ascending chirp to indicate that a stored anchor
position has been retrieved. If the selected anchor position button does not have a
stored anchor position, or if the anchor location is over one mile away from your
current location, the trolling motor will emit an error tone.
IMPORTANT: If the trolling motor loses the GPS signal while in any GPS mode, the
trolling motor will emit an error tone and automatically return to manual mode.
IMPORTANT: When recalling a stored anchor position, the system will calculate a
straight‑line course from your current position to the selected anchor position. Ensure
that there are no obstructions to navigation between your location and the selected
anchor position—the system will recall an anchor point even if obstructions are
present. If obstructions are encountered, navigate around them by operating in
manual mode.
54420
a