MK Diamond MK-101 Pro24 - Manual (Page 31)

31
(J)
Lubricate the Cutting Head
Adjustment Knob.
(K)
Lubricate the Cutting Head
Adjustment Knob retaining
holes.
(L)
Lubricate the Cutting Head
Pivot Shaft.
(A)
Increase cooling flow by releas-
ing the Flow Adjusting Clamp.
(B)
Reduce cooling flow by
Pressing down on the Flow
Adjusting Clamp.
A diamond blade performs best when it is dressed. Over time and use, diamonds on the outer
edge of the blade will become smoothed or “glazed” over. This will reduce grinding efficiency and
may cause the blade to “wander” or bend giving the illusion of an alignment problem. When this oc-
curs, the blade will need to be dressed. The diamond blade can be dressed using the MK Dressing
Stick (part number 152792) and by following the steps below.
(A)
Setup the MK101 for operation
(See Setup, Adjustment
and Operation).
(B)
Set the Adjustable Cutting
Guide to cut a 1/16-strip.
(C)
Position the Dressing Stick. Cut
2 or 3 strips from the dressing
stick to dress the Blade.
FLOW MAINTENANCE
BLADE DRESSING
MK-101 Pro24 MAINTENANCE
NOTE: If flow to the diamond blade requires adjustment, perform the following actions.