MK Diamond MK-101 Pro24 - Manual (Page 26)

26
NOTE: For larger tiles and maximum cutting length, the cutting head should be in the front pivot hole.
(A)
Ensure the ON/OFF Switch
is in the OFF position. Un-
plug the GFCI from the power
source.
(B)
Remove the Blade.
Remove Adjusting Knob.
(C)
Remove the Cutting Head from
the rear pivot hole.
(D)
Install the Cutting Head onto
the front pivot hole.
(E)
Remove the Cutting Head Stop
Bolt. Rotate Cutting Head Stop
to down position and re-tighten
Cutting Head Stop Bolt.
(F)
Install the Adjusting Knob.
(G)
Set cutting depth approximately
1/4 to 1/2 inch below the
surface of the Movable
Cutting Table.
CAUTION
NOTE: For small tiles (6" tile or smaller) the Cutting Head
should be in the rear pivot hole and the Post should be in the
forward post retaining hole. For large tiles and maximum cut-
ting length, the Cutting Head should be in the front pivot hole
and the Post should be in the rear post retaining hole.
NOTE: Move Cutting Head Stop in upward position when us-
ing rear pivot hole and in the down position when using front
pivot hole.
MK-101 Pro24 ADJUSTMENT
ADJUSTING THE CUTTING HEAD
The Cutting Head is heavy! Care must be used when changing the position
of the Cutting Head.