MK Diamond MK-101 Pro24 - Manual (Page 25)

25
(A)
Place the 90º Protractor on
the Ruler/Stop.
(B)
Set the desired angle and
tighten the thumbscrew.
(C)
Position the 90º Protractor
and tighten the
retaining thumbscrew.
(D)
Position the tile against the 90º
Protractor and the Ruler/Stop.
Turn the motor ON.
(E)
Verify proper cooling flow on
both sides of the blade (See
Maintenance Section to
increase/decrease flow).
(F)
Perform the cut. Turn the motor
OFF when work is complete.
CAUTION
MK-101 Pro24 ADJUSTMENT
OFF-ANGLE CUTTING
NOTE: To cut 45º Miters, the 45º Bullnose Miter Guide (MK Diamond Part No. 153201-MK) should
be used.
DO NOT FORCE THE TOOL. It will do the job better and safer at the rate for
which it was designed.