Brada Appliances MPN1-08CR - Manual (Page 7)

3 FAN button
SLEEP FAN
HI
MED
LOW
TIMER ON
TIMER OFF
F C
Used to select the Fan Speed in four steps-
LOW, MED ,HI and AUTO.
light illuminates
under different fan settings except AUTO
speed. Each time the button is pressed,
the fan speed mode is shifted.
The fan speed indicator
NOTE:
4 UP( ) and DOWN( ) button
SLEEP
TIMER ON
TIMER OFF
F C
If you want the display to read the actual
room temperature, see To Operate on
Dry Only" or
section.
"
" To Operate on Fan Only"
The control is capable of displaying
temperature in degrees Fahrenheit or
degrees Celsius. To convert from one
to the other, press and hold theUP and
DOWN buttons at the same time for 3
seconds.
NOTE:
Press to increase Press to decrease
LED Display
SLEEP
TIMER ON
TIMER OFF
F C
NOTE:
Shows the set temperature in C or
F and the Auto-timer settings.
While on DRY and FAN modes, it shows
the room temperature.
" "
" "
O
O
Error codes:
E1-
E2-
E4-
P1-
Room temperature sensor error-
Unplug the unit and plug it back in.
If error repeats, call for service.
Evaporator temperature sensor error-
Unplug the unit and plug it back in.
If error repeats, call for service.
Display panel communication error-
Unplug the unit and plug it back in.
If error repeats, call for service.
Bottom tray is full - Connect the
drain hose and drain the collected
water away. If error repeats, call
for service.
AIR CONDITIONER FEATURES
5
Used to adjust (increasing/decreasing)
temperature settings(1 C/2 F increments)
in a range of 17 C(62 F) to 30 C(88 F) or
the TIMER setting in a range of 0~24hrs..
6