Brada Appliances MPN1-08CR - Manual (Page 18)

REMOTE CONTROLLER ILLUSTRATION
Use the remote controller within a distance of 8
meters from the appliance, pointing it towards the
receiver. Reception is confirmed by a beep.
Location of the remote controller.
8m
CAUTIONS
The air conditioner will not operate if curtains, doors or other materials block the signals
from the remote controller to the indoor unit.
Prevent any liquid from falling into the remote controller. Do not expose the remote
controller to direct sunlight or heat.
If the infrared signal receiver on the indoor unit is exposed to direct sunlight, the air
conditioner may not function properly. Use curtains to prevent the sunlight from falling
on the receiver.
If other electrical appliances react to the remote controller. either move
these appliances or consult your local dealer.
The remote controller is powed by two dry batteries(R03/LR03X2)
housed in the rear part and protected by a cover.
(1) Remove the cover by pressing and sliding off.
(2) Remove the old batteries and insert the new batteries,placing
the(+) and (-) ends correctly.
(3) Reattach the cover by sliding it back into position.
When the batteries are removed, the remote controller erases
all programming. After inserting new batteries, the remote
controller must be reprogrammed.
NOTE:
Replacing batteries
.
Handling the remote controller
TEMP
AUT O COOL DR Y
FAN HIGH MED LOW
MODE
FAN SPEED
SWING
TIMER
ON
ECONOMY ON/OFF
TIMER OFF
RESET LOCK
SET TEMPERA
TURE( F)
LED DISPLA Y
CAUTIONS
Do not mix old and new batteries or batteries of a different type.
Do not leave the batteries in the remote controller if it is not going to be used for 2 or 3 months.
Dispose of the old batteries in the special containers to be found in the sales outlets.
17