Brada Appliances MPN1-08CR - Manual (Page 22)

REMOTE CONTROLLER ILLUSTRATION
Swing operation
Use the SWING button to adjust the Up/Down airflow direction.
1. When press the button once and quickly, the air flow direction setting feature
of the louver is activated. The moving angle of the louver is 6 for each press.
Keep pressing the button to move the louver to the desired position.
2. If keep pressing the SWING button without releasing for 2 more seconds, the
auto swing feature of the louver is activated. The horizontal louver would swing
up/down automatically.
Press it again to stop.
When the louver swing or move to a position which would affect the cooling
effect of the air conditioner, it would automatically change the swing/moving
direction.
o
NOTE:
1
TEMP
AUTO
COOL
DRY FAN
HIGH
MED
LOW
MODE FAN SPEED
SWING TIMER ON ECONOMY
ON/OFF
TIMER OFF RESET LOCK
SET TEMPERATURE( F)
LED
DISPLAY
ECONOMY(SLEEP) operation
When you press the ECONOMY(SLEEP) button, the energy-saving function will
be activated. This function enables the unit to automatically increase(cooling) 1 C
(2 F) per hour for the first two hours, then hold steady for the next 5 hours, after
that the unit will stop operation. It can maintain the most comfortable temperature
and save energy.
The ECONOMY/SLEEP function is only available under Cooling, and
AUTO operation.
NOTE:
1
TEMP
AUTO
COOL
DRY FAN
HIGH
MED
LOW
MODE FAN SPEED
SWING TIMER ON ECONOMY
ON/OFF
TIMER OFF RESET LOCK
SET TEMPERATURE( F)
LED
DISPLAY
Timer operation
press the TIMER ON button can set the auto-on time of the unit. And press the
TIMER OFF button can set the auto-off time of the unit.
1. Press the TIMER ON button. The remote controller shows TIMER ON, the last
Auto-on setting time and the signal "h" will be shown on the LCD display area.
Now it is ready to reset the Auto-on time to START the operation.
2. Push the TIMER ON button again to set desired Auto-on time. Each time you
press the button, the time increases in 30 minutes increments, up to 10 hours,
then at 1 hour increments up to 24 hours.
3. After setting the TIMER ON ,there will be a one-half second delay before the
remote controller transmits the signal to the air conditioner. Then, after
approximately another 2 seconds, the signal "h" will disappear and the set
temperature will re-appear on the LCD display window.
To set the Auto-on time.
1
TEMP
AUTO
COOL
DRY FAN
HIGH
MED
LOW
MODE FAN SPEED
SWING TIMER ON ECONOMY
ON/OFF
TIMER OFF RESET LOCK
SET TEMPERATURE( F)
LED
DISPLAY
TIMER ON
21