Lightforce PRED9X FIREARM MOUNTED LIGHT - Manual (Page 20)

19
OPERATING INSTRUCTIONS
For first use, remove protective insulating film from the batteries. Insert one battery into the
flashlight with the positive terminal facing forward. Replace the end cap.
Fit the lanyard to be able to conveniently handle the PRED6X as a handheld flashlight.
Operate the light using the push button switch on the rear of the PRED6X. For firearm mounted
use, the standard end cap can be replaced with the remote tail switch. This switch has a silicon
boot and features a silent operation switch. The switch has two functions, toggle on/off and
momentary operation in signalling mode. The remote switch may be secured to a riffle stock using
the Velcro adhesive patch that is fitted to the silicon boot of the tail switch.
SCOPE MOUNTING BRACKET
The included scope mounting bracket is made from a non scratch polymer selected to protect
your riflescope. Attach the bracket using the sturdy thumb screw. Clamp the bracket around the
PRED6X and the riflescope. The stepped design of the PRED6X allows it to be adjusted to accom-
modate riflescope diameters between 25mm and 40mm.