Lightforce PRED9X FIREARM MOUNTED LIGHT User Manual
Page 12

11
OPERATING INSTRUCTIONS (cont.)
Operate the light using the push button switch on the rear of the PRED9X. The switch is a
momentary push button that toggles the operating mode: HIGH/LOW/OFF (standby)
•
HIGH provides maximum light output
•
LOW prolongs the operating duration to give up to 7 hours of useable light
•
OFF switches the unit to standby unit ready to be switched on by the RF unit or the on board
button with a single momentary press.
LONG TERM STORAGE INSTRUCTIONS
The PRED9X must be stored in SLEEP mode when not in use. When in SLEEP mode all modes of
the PRED9X are disabled and the internal micro controller is dormant. The RF fob will not operate
when the light is in SLEEP mode. In this mode, accidental operation of the light is protected from
over temperature operation. Also, the internal batteries are isolated reducing current consumption
when in storage.