Lightforce NEW ENFORCER HID - Manual

IMPORTANT: DO NOT CUT ANY PART OF THE INTERNAL BALLAST OR BULB CABLES
1. DO NOT leave light connected to a power source when not in use.
2. DO NOT place light face down on ANY surface. If the light is switched on the intense heat generated
may ignite the surface and cause a melt-down of the lamp body.
3. Ensure all electrical connectors are secure - loose connections will generate excessive heat, damage
wiring and cause electrical failure.
4. The outer lens should be washed clean with copious amounts of water and a clean sponge. Wiping
it with a dry rag will scratch the lens, especially if the surface is dusty. NEVER clean the light with
cleaning fluid or solvent.
5. DO NOT attempt to clean the inside of the light or touch the inside lens and reflector.
6. FOCUSING MECHANISM: The patented focus mechanism allows precise adjustment of the beam to
various concentration patterns as desired. Simply rotate the reflector and select the desired SPOT.
7. Ensure during use reflector surface is not wound too far forward past the globe holder or melting of
the housing can occur and will not be covered under warranty.
8. DO NOT disassemble the light due to high internal voltage!
9. LIGHTFORCE AUSTRALIA PTY LTD shall not be liable for damage, malfunction, failure resulting from
accident, misapplication, misuse, unauthorised repair, neglect, modification, unauthorised or non-
standard replacement parts, accessories, globes, batteries or voltage or the operation of the
product beyond its technical and environmental specifications. The purchaser acknowledges that
local laws may prohibit the use of some of the product on motor vehicles travelling on public roads
and agrees that it is their responsibility to ascertain the effect of local laws.
SPECIFICATIONS:
Weight:
EF170HID - 820 grams*
EF24HID - 1130 grams*
*weight without cable
Operating Voltage at Ballast:
For 12 volt operation 9-16VDC, Nominal 12.8 volts DC
For 24 volt operation 21-29VDC, Nominal 25.6 volts DC
Power Consumption = @ 12 volts 4 amps
Recommended Operating Temperature (ambient)
-40°C > +40°C Maximum (-40°F > +104°F Maximum)
Replacement Bulb - GL24 50W 4200°K
Enforcer HID Instruction Sheet
LIGHTFORCE AUSTRALIA PTY LTD • 28 Orsmond Street, Hindmarsh SA 5007 Australia • www.lightforce.com | email: [email protected]
Australia: Tel: 08 8440 0888 | Fax: 08 8346 0504 • Int’l: Tel: +618 8440 0888 | Fax: +618 8346 0504
All logos and images are subject to relevant trademark and copyright protection LIGHTFORCE Pty Ltd | © Jan 2012 • Data and specifications contained maybe subject to change without notice.
LIGHTFORCE Australia Pty Ltd shall not be liable for damage, malfunction, failure resulting from accident, misuse, misapplication, unauthorised repair, neglect, modification, unauthorised or non standard replacement parts,
accessories, bulbs, batteries or voltage or operation of the product beyond its technical and or environmental specification.
INSTRUCTION DATA
PRODUCT: ENFORCER HID
VER: 1.0
DATE: MAY 2014