Lenze Backup + Restore__Backup+Restore (PC-based) - Manual (Page 15)

1.6 EN - 01/2011
L
15
Control technology | IPC Backup & Restore
Introduction
Using a backup
The more IPC components you select, the more memory space is required on your USB
stick. When creating the first backup, all components should be selected. Data
( 29)
As soon as backups are created at regular intervals, we recommend only to backup the IPC
components that change. These are mainly data. Please read the section Backup with
USB stick
( 27)
to see which data are backed up.
2.4.1 Backup with USB stick
If data of an industrial PC are to be backed up on a USB stick, the USB stick must be
prepared using this software. When the USB stick is prepared, the »IPC Backup & Restore«
on the industrial PC can automatically generate the required backup (depending on the
configuration). Backups are provided with special names which contain information on the
industrial PC. The data which are considered by a backup is described under: Data
( 29)
[2-1] Backup - overview

Note!
A defect on a CF card can only be removed by restoring the archive on another CF
card! When a USB stick is used, the system is always expected to be executable.
As a precaution, always create an archive from a CF card!
USB stick
CF card
Engineering
PC
Industrial
PC
Add backup
USB stick
Configure
Archive
Save backup
Create backup
USB stick
Configured