Lenze EVF9338−EV - Manual (Page 18)

Parameter setting
Parameter setting with the XT EMZ9371BC keypad
Changing and saving parameters
3
l
18 EDKVF93−04 EN 2.0
Action Key
sequence Step
Display of SHPRG or SHPRG p T V Confirm change to accept the parameter
Display "OK"
Display p − The parameter has been accepted immediately
8. Enable the controller, if required U 1) The drive runs again
9. Change to the code level
A V Display of the operating level
B V Display of the code with changed parameter
10. Change further parameters Restart the "loop" with step 1. or 3.
11. Save changed parameters
A z y Z Y Select the code C0003 "PAR SAVE" in the menu
"Load/Store"
B V Change to the parameter level
Display "0" and "READY"
Select the parameter set in which
the parameters are to be saved
permanently C z Save as parameter set 1:
ð Set "1" "Save PS1"
Save as parameter set 2:
ð Set "2" "Save PS2"
Save as parameter set 3:
ð Set "3" "Save PS3"
Save as parameter set 4:
ð Set "4" "Save PS4"
D T V When "OK" is displayed, the settings are permanently
saved in the selected parameter set.
12. Change to the code level
A V Display of the operating level
B V Display of C0003 "PAR SAVE"
13. Set parameters for another parameter
set
Restart the "loop" with step 1. or 3.
1) The function of the S key can be programmed:
C0469 = 1: Controller inhibit
C0469 = 2: Quick stop (Lenze setting)