Lenze MP 9000 DVI Operating Instructions - Manual (Page 31)

Electrical installation
Connecting the supply and peripheral devices
DVI interface
6
l
31 BA_MP9000DVI DE 4.0
6.3.3 DVI interface
)
Note!
Only use the DVI cable from the scope of supply or one of the DVI cables
specified in the following table, featuring a maximum length of 2 m.
Otherwise a faultless signal transmission is not guaranteed.
Greater distances can be covered with the following Lenze accessories:
2 ... 5 m: "DVI/USB" cable set
5 ... 35 m: DVI/USB extender V4
Description Connection type Cable type
DVI interface DVI−D socket
DVI−D single link (18+1)
DVI−D double link (24+1)
IPC001
6.3.4 USB interface
Description Connection type Cable type
USB 2.0 host connection
Max. load: 5 V/500 mA
USB−A socket USB cable with USB−A plug
IPC001
Description Connection type Cable type
USB
USB device connection USB−B socket USB cable with USB−B plug
DVI/USB−010
6.3.5 USB interface on the front face (option)
Description Connection type Cable type
USB 2.0 host connection with
IP 65 cover
Max. load: 5 V/500 mA
USB−A socket USB cable with USB−A plug
EL100−013
)
Note!
If you use USB interfaces routed to the outside, the data integrity cannot be
guaranteed. On the "PC based Automation" DVD you’ll find the "FM Tool"
software which can be used to deactivate the front USB interface if it is not
needed.