Belkin Vision Wireless Router N1 - Manual (Page 65)

61 60 61 60
Using the Web-Based Advanced User Interface
se
ct
io
n
1
9
2
3
4
5
6
7
8
10
Using the Access Point Mode
Note:
This advanced feature should be employed by advanced users
only. The N1 Vision can be configured to work as a wireless network
access point. Using this mode will defeat the NAT IP sharing feature
and DHCP server. In Access Point (AP) mode, the N1 Vision will need
to be configured with an IP address that is in the same subnet as
the rest of the network that you will bridge to. The default IP address
is 192.168.2.254 and subnet mask is 255.255.255.0. These can be
customized for your need.
1.
Enable the AP mode my selecting “Enable”
(1)
in the “Use as
Access Point only” page. When you select this option, you will be
able to change the IP settings.
2.
Set your IP settings to match your network. Click
“Apply Changes”
(2)
.
3.
Connect a cable from the “Modem” port on the N1 Vision to your
existing network.
The N1 Vision is now acting as an access point. To access the N1
Vision’s Web-Based Advanced User Interface again, type the IP
address you specified into your browser’s navigation bar. You can set
the encryption settings, MAC address filtering, SSID, and
channel normally.
(2)
(1)