Model 1205 carry all, Supervisor signature – Landoll ICON 1205 User Manual
Page 34

Model 1205 Carry All
Assembly, Lube, and Check List
_____Install and pin gate into main frame
_____Bolt top cylinder mount onto main frame
_____Attach tongue frame to main frame
_____Install plastic and plastic holder to cylinder mount.
_____Install lift/tilt/gate cylinders. Install all cylinder pins and retaining
clips.
_____Install axle and wheel components. Torque all retaining bolts. Inflate
tires to recommended manufacturer psi.
_____Route hydraulic lines and tighten to proper specs.
_____Install safety lighting components, route wiring, and install
plug retainer.
Cycle and check lighting system with 12 volt system
tester.
_____Lubricate all moving components with high temp grease.
_____Fill hydraulic systems with Mobil 424 hydraulic oil using hydraulic
pump, activate all moving parts and bleed air from the system. Hold
3000 psi. hydraulic pressure
against all cylinders, fittings, and hoses
for a period of 4 minutes. Check hydraulic
components for leaks.
_____Recheck that all retainers are installed and tightened to specs.
_____Clean and touch up paint the machine.
_____Attach operators manual and container.
_____Apply the serial tag, safety, operations, and lube and identification
decals. Attach plastic envelope with warranty return card, and this
check list, at the front of the hose holder.
_____For ease of transporting, unbolt tongue from main frame. (If applicable)
If not, leave blank.
All of the above listed assembly and check functions have been
completed per my rigid standards.
Supervisor Signature_____________________________________________
Serial Number______________________Date_______________
Customer Copy