Kisan Electronics CX-10 - Manual (Page 7)

Page - 5
D
should be vertical – not lay flat
nds on the cable length – to reach the battery
HANDLEBAR MOUNT
ISPLAY INSTALATION
f
For best viewing, the Display
f
Display location depe
Choose an appropriate location
both input
le in place
h 1/8” tie wrap supplied,
.
FLUSH MOUNT
X
Y
Determine how to route
cables
Z
Hold the Mounting Crad
over the handlebar
[
Use eac
and feed them over the half-round
and the handlebar then pull it tight
\
Make sure the cables have enough slack when you steer both ways
X
Choose an appropriate locat
Y
Determine how to route inpu
Z
Clean the mounting surface
thoroughly with an alcohol swab
[
Use the mounting tapes supp
\
Apply pressure to hold it in pl
]
Allow 24 hours for the bond to cure
ion
t cables
lied
ace