Kisan Electronics CX-10 - Manual (Page 14)

Page - 12
charge
X
CX-10
charger. It is designed for mounting on your
ently. Choose a suitable mounting location:
water spray
the Status LED is visible
Locate it such that there’s ample room to
connect the wiring harness to the battery
posts. Make sure there’s enough
clearance to re-install any side panels
you may have removed.
During the Fast Charge mode of
t it
d
RJ22 port is used for
programming and
future use only
.
chargeX is an onboard
motorcycle perman
„ Near the terminal po
„ Away from any direct
„ Position it so that
sts of the battery
operation, the chargeX unit can get
VERY HOT! (
200F) Do not mount it
on plastics, or near any gas lines, or le
get in contact with other wires.
„ Attach Red wire to the Positive post of battery
ire to the Negative post of the battery
„ Attach Black w
„ Plug the Molex connector in the socket near the AC cor
DANGER OF PERSONAL INJURY! Do not hold this appliance
or touch it by hand, while it is charging.
Typical chargeX installation