Kisan Electronics CX-10 - Manual (Page 11)

Page - 9
INSTALLATION
Shunt installed on the NEGAT
(Ground) post of the battery.
„
COPPER EYLET towards the
battery post
Power wire must be attached to
URE
IVE
„
the Positive post of the battery.
ZERO SET FEAT
DO NOT BEND the Current Sensor. Keep it
ground cable as shown.
as been calibrated for zero-
offset values are stored in
the Display.
null point:
n
Turn everything Off – no load on the battery
o
Push the Mode button momentarily to show AMP screen
p
If the AMP reading is
q
Let the Display scroll .
The Display backlight will
r
AMP icon will begin flashing – now release the Mode button
T
y
The Integrated Shunt h
set at the factory. The
permanent memory of
If you need to reset
not zero, Push & Hold the button
through twice & return to AMP mode
go dark.
free by rotating it away from the
he reading will be set to zero and the new offset values for the null point
ou have chosen will overwrite the factory setting.