Kisan Electronics CX-10 - Manual (Page 13)

Page - 11
INSTALLATION
This new version of the
Temperature Sensor is
molded on the end of the
cable. It is not detachable.
Route the cable and make
sure that the cable does not
rub against any sharp edge or can pinch tightly
between panels. Do not place it too close to the high voltage spark plug
wires.
TRIM FEATURE
The Temperature Sensor has been calibrated at the factory
you need to adjust the Temperature display:
n
Turn everything Off –
o
Push the Mode button momentarily
TEMP screen
p
If TEMP reading needs trimming, Push & Hold
the button
q
Let the Display scroll through twice & return to
TEMP mode
r
TEMP icon will begin flashing – release the Mode button
s
Push Mode button to set the value (+/- 7 °F) then release
The new reading will be shown and the offset values for the
reading you have chosen will overwrite the factory setting. This feature
can be activated in the °F or °C.
. However, if
for at least 10 minutes
to show