Kisan Electronics CX-10 - Manual (Page 19)

Page - 17
FAQs:
Q: I have installed the chargeX on my bike but the location is such that I
cannot see the status LED. Can I extend the wi s for the battery
connection and relocate the chargeX?
A: That is one option. An extended length (4ft)
Q: My chargeX has been charging the battery (LED is flashing slowly) for
the past 4 or 5 hours. Is there something wrong? Should I unplug it?
A: char
.
Once it ged into AC outlet, it begins
the proc
to check
enough.
That’
to let in
mem am cycles will be executed.
This memory retention i
connected to the battery
Q: I replaced my battery
eX
A: chargeX
Anything below 6v is inte
re
harness is available.
geX has built-in multiple charging programs stored in its memory
connected to the battery and plug is
ess of determining the type of battery, state of battery charge and
for any sulfate build-up on the battery plates - if plugged in long
s why it’s best to keep the chargeX plugged in for at least 12 hours
it execute all applicable program cycles and retain the best match
ory. Next time, only ogr the optimum pr
s valid for as long as the chargeX remains
.
with the new Gel-cell type. Do I have to
reprogram the charg ?
A: No, the chargeX will automatically detect the new battery type and
adopt the most efficient charging program to execute.
Q: No matter what I do the chargeX keeps showing 2-flashes. I have
checked the battery connection and it is proper. What’s wrong?
is an on-board 12v charger. It’s operating range is 6v – 14v
rpreted as an open connection.