Kisan Electronics CX-10 - Manual (Page 10)

Page - 8
CURRENT SENSOR
This new version of the Current Sensor or
Shunt is fully Integrated and mounts on the
NEGATIVE (Ground) battery post.
„ Sh
curre
INSTALLING CURRENT SENSOR:
unt is rated for 100 Amps MAX
nt
X
Remove ALL cables from the
NEGATIVE post of the battery.
Y
Align the eyelet of the Current S
with Copper-side facing the battery
ensor
post as
shown.
Keep all cables so that they are they are
n the other side of the eyelet of the shunt.
el
most cases, you can remove the
ROUND cable bolt and slip the
Current Sensor between the cables
and the battery post.
Z
o
[
Use the CALIBRATED stainless ste
bolt supplied to reassemble,
In
G
„ Using non-calibrated bolt will result in inaccurate AMP display
n. „ Improper orientation of Shunt will cause wrong current flow directio