Offsets and look aheads, Offsets – Kinze ISOBUS Electronics Package (4900) Rev. 4/14 User Manual
Page 37
TM
ISOBUS
M0250
Rev. 4/14
33
Offsets and Look Aheads
OFFSETS
The offsets for the planter will be prepopulated in the Task Controller. It is recommended that these measurements are
checked and adjusted on each planter. Also ensure that the measurements for the tractor are entered and correct.
Below is an example of John Deere’s offset entry screen for the planter. Measurements will be prepopulated in this
screen but the measurements need to be confirmed on the planter prior to planting.
John Deere’s Change Planter Offsets Screen