KD Scientific Legato 100 Series - Manual (Page 54)

54
Operating the KDS Legato 100 Series
K
D
S
L
e
g
a
to
1
0
0
S
e
ri
e
s
U
s
e
r’s
M
a
n
u
a
l
KD Scientific Legato 100 Series Syringe Pump User’s Manual
Publication 5617-006 Rev D
VERSION
Displays the full version string.
Command format:
version
Query response:
[##:]Firmware: v#.#.#
[##:]Pump address: #
[##:]Serial number: C ######
[##:]Device ID: ########
[##]
Run commands
IRUN
Runs the pump in the infuse direction. Configuration Run
screen mode only.
Command format:
irun
RRUN
Runs the pump in the opposite direction. Configuration
Run screen only.
Command format:
rrun
RUN
Simulates a key press of the run button located in the lower
right corner of the screen.
Command format:
run
STOP / STP
Stops the pump.
Command formats:
stop
stp
WRUN
Runs the pump in the withdraw direction. Configuration
Run screen mode only.
Command format:
wrun
Rate commands
CRATE
Displays the current rate that the motor is running at. A
valid response is returned only in dynamic situations (if
the motor is running). Configuration Run screen mode
only.
Command format:
crate
Query response:
[##:]Infusing at # xl/xxx
[##]
or:
[##:]Withdrawing at # xl/xxx
[##]
DIAMETER
Sets or displays the syringe diameter in mm.
Configuration Run screen mode only.
Command format:
diameter [{syringe diameter}]
Query response:
[##:]#.#### mm
[##]
IRAMP
Sets or displays the infusion rates while ramping.
Configuration Run screen mode only.
Command format:
iramp [{start rate} {start units} {end rate} {end units}
{ramp time in seconds}]
Query response:
[##:]Ramp not set up.
[##]
or:
[##:]# xl/xxx to xl/xxx in # seconds
[##]
phone
508.429.6809
fax
508.893.0160
e-mail
[email protected]
web
www.kdscientific.com