KD Scientific Legato 100 Series User Manual
Page 27
27
Configuring the KDS Legato 100 Series
K
D
S
L
e
g
a
to
1
0
0
S
e
ri
e
s
U
s
e
r’s
M
a
n
u
a
l
KD Scientific Legato 100 Series Syringe Pump User’s Manual
Publication 5617-006 Rev D
Resume Run on Power Loss
If Resume Run on Power Loss is selected the pump will
power up running when power resumes.
In the Set-up screen,
select
Resume Run After Power Loss
Accept
the changes made and go back
to the previous screen before Set-up mode
was selected.
Cancel
and go back to the previous
screen before Set-up mode was selected.
✐
NOTE: This feature is only valid in Infuse
Only or Withdraw Only modes. This feature
will only execute if the pump is running at
the time when power is lost, and was
running with no target set.
Press Here
Press Here
Setting and Viewing Pump Information
The information on the pump’s parameters are displayed
in the Pump Information Screen.
In the Set-up screen, select
Pump Information
The current information on the pump will be displayed.
• The Model type
• The Software Version
• The Maintenance Due
• The Current Pump Address
Press
Maintenance Reset
to reset the # of hours
for maintenance. This will reset it to 100 hours.
Confirm the Maintenance Reset by pressing the
Maintenance Reset
again.
Accept
the changes made by pressing
and go back to the Set-up screen.
Cancel
the changes made by pressing
and go back to the Set-up screen.
Press here to
reset the
maintenance
counter
phone
508.429.6809
fax
508.893.0160
web
www.kdscientific.com
✐
NOTE: Elapsed Timers and Total Infused
Volume will be reset when power resumes.
Counters and timers information prior to
loss of power are lost