KD Scientific 200 Series - Manual (Page 24)

20
KDS Model 200 Series KDS Model 200 Series
Programmable Option– Menu Operation
After selecting MODE and then PROGRAM the display will show STEP which leads into edit-
ing the program.
1) Number of STEPS
Menu prompts " NUM of Steps". Enter total number of program steps using
numerical keypad and press SELECT or ENTER to save a maximum of 8.
2) Edit STEP #
The menu automatically increments the step number, however, it is possible to enter
a different number.
If the step number displayed (flashing) is required then press SELECT to save and
continue editing.
3) Time
Step # Time xx:xx:xx.
Time xx:xx:xx in hours, minutes and seconds.
Use the key to move from left to right and enter the time using the numerical
keypad. When the correct time is displayed press ENTER to load this time into
memory.
4) Infusion/ Withdraw
The direction of travel for each step must be selected.
Initially, " Infusion " direction will be flashing. The direction keys, and are
used to switch between directions. SELECT key is then used to load the direction
into memory.
5) Rate
The program requires the initial rate (Start), the ending rate (End), and the units.
a) Display reads: #Start: xxxxx uuu
# is step number, automatically assigned.
xxxxx is the numerical flowrate.
Enter from the numerical keypad.
uuu are flowrate units.
Use the arrow key to select units (displayed flashing)
Repeat to move through the unit options. Options are: µl/m or µl/h,
ml/m or ml/h
The key is used to move back to the numerical display.
Press ENTER to save.
The menu now prompts for the final rate which is entered in the
same manner.
b) #End: xxxxx uuu
xxxxx numerical and uuu units of flowrate
➔
➔
➔
➔
➔