JUMO 706585 LOGOSCREEN fd Recorder with diecast zinc front Installation Instructions - Manual (Page 35)

35
6 Technical data (extract from data sheet)
6.5 Screen
6.6 Electrical data
USB host (connector 5)
• quantity 2 (or 1 with stainless steel front),
connector 5 and front connector (not with stainless steel front); no
parallel operation
• use for connecting a memory stick
• max. current 100 mA
USB device (connector 15)
• quantity 2 (or 1 with stainless steel front), connector 15 and front connector
(not with stainless steel front); no parallel operation)
• use for connecting to the (master) computer
Resolution/size 320 × 240 pixels/5.5"
Type/number of colors TFT color screen/256 colors
Screen refresh rate > 150 Hz
Brightness setting adjustable on instrument
Screen saver (switch-off) through waiting time or control signal
Supply voltage (switch-mode PSU) AC 100 to 240V +10/-15%, 48 - 63Hz or
AC/DC 20 to 30V, 48 - 63Hz (ELV)
Electrical safety to EN 61010, Part 1, August 2002
overvoltage category II, pollution degree 2
Protection class I terminal for PE conductor
Test voltages (type test)
• mains supply circuit to meas.
circuit with AC supply: 2.3 kV/50 Hz, 1 min,
with AC/DC supply: 2.3 kV/50 Hz, 1 min
• mains supply circuit to housing
(protective conductor) with AC supply: 2.3 kV/50 Hz, 1 min,
with AC/DC supply: 2.3 kV/50 Hz, 1 min
• measuring current circuits to
measuring current circuit and
housing
500 V/50 Hz, 1 min
• electrical isolation between
analog inputs
up to 30 V AC and 50 V DC
Supply voltage error < 0.1 % of range span
Power consumption approx. 40 VA
Data backup CompactFlash memory card
Electrical connection
• mains supply and relays at rear through pluggable screw terminals, 5.08 mm raster,
max. conductor cross-section
 2.5 mm 2
or 2× 1.5 mm
2
with ferrules
• analog and binary inputs at rear through pluggable screw terminals, 3.81 mm raster,
max. conductor cross-section
 1.5 mm 2