JUMO 705040 mTRON T - Router Module Installation Instructions - Manual (Page 31)

31
4 Appendix
4.1 Technical data
4.1.1 Interfaces
4.1.2 Electrical data
Bus In (system bus)
Application For connection of a base unit, a router module or a multifunction
panel
Number 1
Connection At the front, RJ45 socket
Connection cable Network cable (patch cable or crossover cable), at least CAT5 (S/
FTP)
Cable length Up to 100 m
Bus Out1 and Bus Out2 (system bus)
Application For connection of further router modules or a multifunction panel
Number 2
Connection At the front, RJ45 socket
Connection cable Network cable (patch or crossover cable), at least CAT5 (S/FTP)
Cable length Up to 100 m
Voltage supply
Connection At the front (removable 2-pole terminal strip with Push-In technol-
ogy)
Voltage input DC 24 V +25/-20 % SELV
Residual ripple 5 %
Current consumption 100 mA (at DC 19.2 V)
Current consumption of lined-up modules also has to be considered
(see „Hardware configuration“ in the setup program)!
Power consumption 2 W
Conductor cross section (voltage supply)
Wire or strand without ferrule Min. 1.5 mm 2 , max. 2.5 mm 2
Strand with ferrule Min. 1.5 mm
2
, max. 2.5 mm
2
2 x strand with twin ferrule
with plastic collar 1.5 mm
2
Stripping length 10 mm
Electrical safety Acc. to DIN EN 61010-1
Overvoltage category III, pollution degree 2
Electromagnetic compatibility Acc. to EN 61326-1
Interference emission Class A – only for industrial use –
Interference immunity Industrial requirements