JULABO F1000 Recirculating Cooler - Manual (Page 30)

Cleaning / repairing the unit
30 1.951.4806-V1
11. Cleaning / repairing the unit
Danger of electric shock!
•
Always turn off the unit and disconnect the mains cable from
the power source before cleaning the unit.
•
Prevent humidity from entering into the circulator.
•
Electrical connections and any other work must be performed
by qualified personnel only.
Venting grid (front)
F250
F500, F1000
To maintain the full cooling performance, clean the
condenser from time to time.
1. Switch off the unit
2. disconnect mains power cable.
3. Clean the ribbed condenser with a vacuum cleaner.
Cleaning:
Clean the outside of the unit using a wet cloth and low surface
tension water.
The recirculating cooler is designed for continuous operation
under normal conditions. Periodic maintenance is not
required.
The tank should be filled only with a bath fluid recommended
by JULABO. To avoid contamination, it is essential to change
the bath fluid from time to time.
Repairs:
Before asking for a service technician or returning a JULABO
instrument for repair, please contact an authorized JULABO
service station.
JULABO Technical Service
Tel.: +49 7823 / 51-66
Fax: +49 7823 / 51-99
E-Mail:[email protected]