Johnson Systems CD-3000 Series Retrofit Control System User Manual
Page 9
9
• Connect all other applicable low voltage control input/output connections
to the backplane.
• Connect the power connector (square, white, 12-position connector) into
its mate mounted on the CD-3000-SV chassis. The connector is keyed
so it can only be inserted one way. Push the connector in until a “click”
is heard and the clamps locked indicating that the connector is fully
seated. Refer to page 11 for the connector pinout.
• Carefully slide the CD-3000-SV into the rack using the rails for the
old fan housing. Be sure not to pinch or stress any wires or cables.
Secure in place using the four (4) 10-32 x 3/8” screws provided.
• Place the new air filter grill assembly over the bottom opening of the
rack. Secure in place using the four (4) 10-32 x 1 3/4” screws provided.
The air filter grill assembly is precisely engineered to allow for safe air
flow and filtration. The air filter and frame can be easily removed for
cleaning and maintenance. Pushing up on the filter frame will free it to
be pivoted out. Always ensure the filter frame is fully seated and secure
before installing the CD-3000 air filter grill assembly. The air filter should
be removed from the rack and cleaned annually using compressed air.
WARNING! Never connect power with the air filter grill assembly removed.
• Connect (turn on) the power supply to the Strand CD80
®
dimmer rack(s)
and CD-3000.
• Verify system status LED indicators and LCD display.
Refer to page 17 and 18 for details.
• Refer to the programming section of this manual for system setup.
Refer to page 19 to 34 for details.
• Test the system thoroughly to ensure all wiring terminations are
functioning and the control signals to the dimmers have the correct
phase referencing.
• Verify fan operation. The fans are triggered on at 6% DMX input control,
and stay on as long as the DMX is at 6% or greater. When the DMX
input is brought down below 6%, there is a 5 minute timeout for the fans
to turn off.
CD-3000-SV-48RR
• In development.
CD-3000-SV-96RR
• In development.
CD-3000-C21
• In development.