INFICON Stripe CDG045Dhs 0.01 ... 1000Torr / mbar, new 10mTorr - Manual (Page 30)

30 tina84e1 (2014-07)
4.3.1 Adjusting the Setpoints SP1, SP2
The thresholds of the setpoints can be adjusted via
• the buttons on the gauge
• the diagnostic port (→  [4])
• the EtherCAT interface (→  [3]).
DANGER
DANGER: malfunction
If processes are controlled via the signal output,
keep in mind that by pushing an button the
measurement signal is suppressed and the cor-
responding threshold value is output instead. This
can cause malfunctions.
Push the button only if you are sure that no
malfunction will cause.
The setpoints can be adjusted via
• the buttons on the gauge,
• the diagnostic port (→  [4])
• the EtherCAT interface (→  [3]).
Adjusting Setpoint <1>

Push the button with a pin (max. ø1.1 mm). The
gauge changes to the switching function mode and outputs
the current threshold value at the measurement value
output for about 10 s (LED <1> blinks).