INCRA Side Winder 350 Router Lift - Manual (Page 3)

Made in the U.S.A. by Woodpeckers Inc., North Royalton, Ohio · Copyright 2010© Woodpeckers Inc. 8/10 Page 3
SIDE CRANK INSTALLATION ON A
WOODPECKERS
® ROUTER TABLE STAND
This section assumes you’re installing the Side Winder onto
a Woodpeckers
® Router Table Stand.
STEP 9. Remove the existing hex bolt from the inside cor-
ner of the router table stand and attach the side panel using
one of the connector bolts and hex nuts. (Figure 9).
Figure 9.
Side panel.
Connector bolt.
STEP 11. First slip the pin into a coupling until it bottoms
out. Tighten the set screw onto the flat of the pin. Now
push the flex shaft into the other end of the coupling. Tight-
en the remaining set screw onto the flex shaft. Now loosen
the first set screw and remove the pin. You’ll need it for the
next step. (Figure 11).
Figure 11.
1st
2nd
Pin.
Flex shaft.
Coupling.
Figure 12.
STEP 12. Insert the pin into the
remaining coupling and tighten
the set screw on the flat just like
before. Set the coupling aside
for now and thread the bare end
of the flex shaft up through the
bearing in the bracket. Secure
the coupling onto the end of the
flex shaft. Now both ends of the
flex shaft should have couplings
attached and the end going up
through the bracket should have
the pin installed as well. (Figure
12).
STEP 10. Using the side panel as a guide, drill two 9 ⁄
32
dia.
holes through the router table stand. Fasten the panel in
place using the remaining two connector bolts and nuts.
(Figure 10).
Drill 9 ⁄
32
hole in these
two locations.
Figure 10.
Figure 8.
Clamp block.
Clamp knob.
STEP 8. Once your router motor and the two clamp blocks
have been installed, remove the Side Winder from the table
and set it back in, right side up. From underneath the table
rotate the clamp blocks in place and tighten the two knobs.
The clamp blocks hook under the edge of the table opening.
(Figure 8).
Flex shaft.
Bracket.
DO NOT OVERTIGHTEN THE BOLT. Overtightening will
damage the plate. Snug the hex nut against the plate. (Fig-
ure 7b). Repeat the same steps for the other clamp block.