INCRA Router Table Stands Addendum - Manual

w w w. i n c r a . c o m
®
Manufactured by:
Taylor Design Group, Inc.
P.O. BOX 810262 Dallas, TX 75381
www.incra.com INCRA Tools are protected by one or more of the following US patents:
#4,793,604, #4,930,221, #5,195,730, #5,275,074, #5,423,360, #5,716,045, #6,237,457,
#6,557,601, #6,672,190. Other patents granted or pending. rev.11.03.10
INCRA is a Registered Trademark of Taylor Design Group
©2009 Taylor Design Group, Inc.
Side Winder Side Crank Installation on INCRA
Router Table Stands
Note: This addendum replaces Fig/Step 10 & Fig/Step 11 of the Woodpecker provided mounting instructions.
Please follow all assembly instructions of the original manual up to Fig/Step 10 before using this addendum.
MADE IN THE
USA
If your INCRA router table stand is already assembled you will first need to remove the table top and remove the
front top stretcher. Remove the lower 1/4-20 x 1/2” hex bolt from the left end of the stretcher,
Fig. 1. Loosely
attach the Side Winder Crank’s side panel to the stretcher using the provided 1/4-20 x 7/8” hex bolt, washer
and square nut. Place another 1/4-20 x 7/8” hex bolt with washer
through the lower hole on the Crank’s side panel and add the large
gold washer to the fastener before loosely threading on the square
nut,
Fig. 2.
Re-assemble the stretcher to the stand sliding all 3 of the square
nuts on the left end of the stretcher into the t-slot in the leg.
Make sure the Crank’s
side panel is parallel
to the leg before
tightening all of the
mounting bolts,
Fig. 3.
Using the remaining
hole in the side
panel as a guide,
drill a 9/32” hole
through the front
stretcher,
Fig. 4.
Place a flat washer
on the remaining 1/4-20 x 7/8” hex bolt and insert through the
hole on the side panel. Add a split lockwasher and a square nut
then tighten the assembly in place,
Fig. 5.
Continue with Fig/Step 12 in the Side Winder Owner’s Manual.
Fig.1
Fig.2
Remove front
stretcher and remove
lower hex bolt from
left end
Fig.4 Fig.5
1/4-20x7/8
hex bolt with
washers
Square
nuts
Large washer
this bolt only
Square nuts
captured in
T-Slot on Leg
Re-assemble Stretcher to Stand Fig.3
Drill 9/32”
hole through
stretcher
1/4-20x7/8
hex bolt with
washer.
Secure with
lockwasher
and
square nut