INCRA Side Winder 350 Router Lift User Manual

Side winder, Woodpeckers

8/10 Page 1

SAFETY

Always unplug your router motor before making any
adjustments to the router lift. Refer to your routers’ owners
manual for specific safe operating instructions.

BEFORE YOU BEGIN

The Woodpeckers

Side Winder can be installed in most

router tables with a standard 9¼ x 11¾ opening and a side
panel mounting surface no more than 19" away as in the
side of a cabinet or router table stand. In most cases three
holes will need to be drilled for mounting the side plate.
These instructions assume you’re installing the Side Winder
on a Woodpeckers

Router Table Stand.

Woodpeckers

Router Table Stand, Router Table and Side Winder.

COMPATIBLE ROUTER MOTORS

The Woodpeckers

Side Winder 350 Router Lift fits the

Porter-Cable 690/890, Bosch 1617/1618 and Craftsman
models 17542, 17540, 28190 router motors as well as any
router motors 3.5" in diameter.

Made in U.S.A. by Woodpeckers Inc.
Protected by one or more of the following U.S.
Patents; 6,505,659; 7,559,347; 7,481,253;
7,108,463 and other patents pending.

INSTALLATION INSTRUCTIONS

Models: SW350

Woodpeckers

PRECISION WOODWORKING TOOLS

Side Winder

Router Lift.

USING THE LIFT WRENCH

You’ll need to know how to use the Lift Wrench to install
your router motor.
STEP 1. To change the carriage height (the carriage is the
part beneath the table that holds the motor), orient the
wrench with the handle pointing right. (Figure 1.)
Insert the wrench until it’s COMPLETELY BOTTOMED OUT.
Once it’s all the way in, try and rotate it. If it doesn’t turn, it
isn’t in. Do not force the wrench. Take it out, push it back
down and try again.
STEP 2. Once it turns easily, simply rotate it ¼ turn in ei-
ther direction to lock the handle to the carriage. Now you
can raise or lower your router as needed using the wrench.
(Figure 2.)
To install your router motor you need to raise the carriage
all the way up and lock it in place by once again orienting
the handle to the right. Now remove the lift wrench.

Once fully
inserted, rotate
the wrench

turn in either
direction and
completely raise
the carriage.

Carriage

Figure 2.

The wrench
handle must
be pointing
right in order
to fully insert
or remove it.

Lift Wrench

Figure 1.