Plate leveling options, Mounting the cleansweep cabinet – INCRA CleanSweep Adaptor User Manual

Page 2

w w w. i n c r a . c o m

Manufactured by:

Taylor Design Group, Inc.

P.O. BOX 810262 Dallas, TX 75381

www.incra.com

INCRA Tools are protected by one or more of the following US patents:

#4,793,604, #4,930,221, #5,195,730, #5,275,074, #5,423,360, #5,716,045, #6,237,457,

#6,557,601, #6,672,190. rev.05/13

MADE IN THE

USA

Plate Leveling Options

As previously mentioned, the CleanSweep Adaptor
provides a variety of options for later leveling your rout-
er plate or lift. Review the options below to determine
the best approach for your situation before mounting
your CleanSweep Cabinet.

OPTION 1:

If you plan on using only your existing corner

mounted levelers to level your router plate, you can re-
move the (10) 5/16-18 X 1-1/2” Socket head fasteners,
Fig 3. Tip: The fasteners can also be left in place on the
adaptor. Just screw them down so the head does not
interfere with your router plate.

OPTION 2:

If you would like to use some or all the

(10) 5/16-18 x 1-1/2 Socket head fasteners to supple-
ment or replace your existing equipment for leveling
any Non-INCRA router plate, remove then re-install the
fasteners so that the socket heads will be accessible
from the underside of the table,

Fig 4.

OPTION3:

If you want to upgrade to any INCRA Mag-

naLock Router Plate or Lift, the fasteners can be left in
place for easy adjustability from the top of the table
through the access holes provided in all INCRA Mag-
naLock Plates and Lifts,

Fig 5.

Fig.6

use shorter

#10x1-1/4” wood

screws with washers

in (2) holes over

Miter Channel

Mounting the CleanSweep Cabinet

Align the CleanSweep Cabinet over the (8) remaining
mounting holes on the adaptor. The Blast Gate Slide
pull tabs should be oriented facing the infeed side of
the table. Through the (2) mounting holes over your
router table’s miter channel, use the shorter #10 x
1-1/4” wood screws with washers to attach the Clean-
Sweep to your table. For the remaining (6) holes, use
the longer #10 x 1-1/2” wood screws with washers,

Fig 6.

You can now return to Step 4 in the CleanSweep Owner’s
Manual to complete your CleanSweep installation.

use longer

#10x1-1/2” wood

screws with

washers in (6)

remaining

mounting holes

Fig.3

Plate Leveling Option 1

remove (10)

socket head

fasteners to use

corner levelers

only

Fig.4

Plate Leveling Option 2

remove then reinstall

fasteners from

bottom to augment

or replace existing

leveling system

Fig.5

Plate Leveling Option 3

INCRA MagnaLOCK™

Plate

leave socket head

fasteners in place

for through the

plate adjustability

with INCRA

MagnaLOCK™

Plates and Lifts

Miter Channel