Adjustable angle crosscut – INCRA Build-It Starter Kit User Manual
Page 6
S
imilar to Plan #001 (Adjustable Angle Crosscut with Drop Panel), this crosscut jig has a shorter 18” fence and uses fewer components
to achieve comparable functionality. The T-Track Plus and user made stop positioner provide repeatable crosscut length control.
The rear mounted T-Track Regular combined with a pair of Build-It Brackets and the twin T-Slot Panel Connectors allow for
unlimited adjustment of the fence angle.
Begin by adding a Miter Slider to a small Build-It Panel. Place in your table saw’s miter slot and adjust for a good fit, then add
a T-Slot Panel Connector to each edge. Increase the platform width to cross the line of cut by adding the large Build-It Panel.
Trim to the blade as described in Steps 3 & 4 shown on the reverse side of your Build-It Panel’s wrapper then mount the cutoff
from the large panel to the opposite
side of the small panel. Make the 18”
fence and stop positioner as shown in
Fig. 3 and Detail 3A using 18” T-Track
Regular and T-Track Plus components
then attach to the T-Slot Panel Connec-
tors using a pair of Built-It Brackets. Now
you can adjust the fence to the desired
angle, clamp your workpiece in place
and begin your project’s crosscut re-
quirements with confidence.
Adjustable Angle Crosscut
Fig.1
Fig.2
Fig.3
Build-It Platform Components Required:
• 1 Large Build-It Panel • 1 Small Build-It Panel
• 1 Miter Slider
• 2 T-Slot Panel Connectors
• 18” T-Track Regular
• 18” T-Track Plus
Just add:
w w w.incra.com rev
. 10.12.07
©2007 by Taylor Design Group. All rights reserved.
System
it
®
Large Build-It Panel
(trimmed to blade)
Attach cutoff from
Large Build-It Panel to opposite
side of Small Panel
18” T-Track Regular
18” T-Track Plus
Plan #
007
Detail 3A
5 /1
6”
d
ia
ho
le
s
2
1
/
16
”
3
/
4
”
2”
1
1
/
8
”
3
1
/
2
”
2
3
/
16
”
3
/
4
”
1
3
/
4
”
1
1
/
4
”
5
/
8
”
3
/
4
”
wide
x
1
/
2
”
deep
groove for
T-Track
3
/
4
”
1/
4-20 x 1” hex bolt (4)
1/
4-20 x
1
1/
2” hex
bolt
Small Panel
Available online at w w w.incra.com
• Build-It Brackets
• Build-It Clamp
• Build-It Knobs